Echo PPT-2400 Bedienungsanleitung PDF herunterladen (Seite 38)

16A

4. Tighten the 10mm linkage nuts (E).

5. Check throttle for freedom of movement and make sure it returns to

idle position. If the throttle linkage does not allow the carburetor

throttle plate (C) to return to idle against idle screw (D), loosen

linkage nuts; turn throttle linkage nut (E) counter clockwise until

throttle plate (C) rests against idle screw (D). Hold linkage nut (E)

from turning and tighten other linkage nut.

6. Connect ground wire terminal under screw (F) on fan housing.

7. Connect stop switch wire to stop wire (G) on engine.

SAW CHAIN TENSION ADJUSTMENT

Tools Required: 10x19mm (13/32x3/4in.) T-wrench provided

WARNING DANGER

Always wear gloves when handling saw chain, otherwise serious

personal injury may result.

To Adjust Saw Chain Tension.

1. Loosen two (2) 10 mm (13/32 in.) guide bar nuts (A) located on

cutting attachment using the T-wrench provided.

2. Turn saw chain tensioner screw (B) (located next to guide bar in

sprocket cover) clockwise to tighten saw chain on guide bar.

Turning screw counter clockwise will loosen saw chain on guide

bar.

3. Tighten guide bar nuts firmly. Move saw chain backwards on guide

bar by hand. Saw chain should move freely on guide bar if it is in

proper mesh with sprocket.

Keep the saw chain lubricated and properly adjusted and the guide bar

nuts tightened firmly at all times. If saw chain is difficult to rotate or

binds on guide bar, it is too tight.

1 2 ... 33 34 35 36 37 38 39 40

Keine Kommentare

Echo PPT-2400 Bedienungsanleitung Seite 38