Echo PPT-2400 Bedienungsanleitung PDF herunterladen (Seite 15)

POWER PRUNER

OPERATOR'S MANUAL

2. Loosen center clamp knob (F) turning counter clockwise.

3. Pull upper shaft tube (G) out of fiberglass lower shaft tube 127-152

mm (5-6 in.), then slide (G) back into fiberglass lower shaft tube

exposing inner power transmission shaft (H). Align and join star

shaped drive end of inner power transmission shaft (H) with cutting

attachment shaft (I).

4. Align ridges on upper shaft tube (G) with seams in cutting attach-

ment.

5. Slide together aligning locating screw (J) in cutting attachment with

locating hole (K) in upper shaft tube.

6. Tighten locator screw (E). Tighten four (4) cutting attachment

screws (D).

7. Extend upper shaft tube to desired length. Tighten center clamp

knob (F) turning clockwise.

THROTTLE LINKAGE INSTALLATION

NOTE

The engine is delivered separated from shaft tube. The throttle

linkage and stop switch wires are attached to the rear handle.

1. Loosen outer 10mm nut (E) on throttle linkage.

2. Insert throttle linkage in fan cover slot (A).

3. Finger tighten nut (E) and attach the inner linkage to the swivel (B)

on the carburetor throttle plate.

NOTE

It is important that the head of the throttle linkage fits inside the

slot well of the swivel (B).

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 39 40

Keine Kommentare

Echo PPT-2400 Bedienungsanleitung Seite 15