Echo MS-31H Bedienungsanleitung PDF herunterladen

WARNING

Parts, Piezas, Pièces

99944100484

Flat Fan Nozzle

Tobera

Buse

2. Assembly of Shut-off, Extension Wand and Nozzle

1) Screw nozzle assembly onto threaded end of the extension wand securely.

2) Insert unthreaded end of extension wand into shut-o assembly as shown and tighten retaining

nut securely.

3. Filter

e lter helps prevent clogging while spraying. It is located on the end of the white tube inside

your sprayer tank.To clean lter, remove the hose from the tank and lift out the outlet tube. Make

sure the lter is positioned at the bottom of the tank as pictured.

4. Pre-Use Check

5. Filling

1) Do: Turn pump handle counterclockwise and remove pump

2) Do: Prepare spray solution following all directions and safety warnings on chemical label.

3) Do: Fill tank to no more than the proper gallon marker. Do NOT: overll to accommodate pump.

4) Do: Check pump to make sure that no grass or dirt is stuck to barrel. Replace pump in tank and tighten securely.

8. Care, Storage and Maintenance

WARNING: Handling the brass parts of this product

will expose you to lead, a chemical known to the

State of California to cause birth defects and other

reproductive harm. Wash hands after handling.

013544 (A) R0514

Note: Your particular sprayer may not include all parts pictured above.

Nota: Es posible que este pulverizador en particular no incluya todas las partes que se ilustran arriba.

Remarque : Votre pulvérisateur particulier pourrait ne pas inclure toutes les pièces illustrées plus haut.

Filter

For safety lock-o feature (no-spraying), pull up on handle and move red locking mechanism into lock-o position as shown in g. 9a.

To disengage, push down on handle and return red locking mechanism to neutral position as in g. 9c. For lock-on feature (continuous

spraying), push down on handle and move red locking mechanism into lock-on position as shown in g. 9b. To disengage, push down on

handle and return red locking mechanism to neutral position as shown in g. 9c.

9. Fatigue-free spraying

Nozzle Assembly

Figure 1-2

Unscrew the nozzle cap (1) from the nozzle body (3) with retaining nut (2) fastened tightly to the elbow (5). Unscrew the retaining nut

(2). Push the nozzle body (3) with the nozzle gasket (4) out of the retaining nut (2). To reinstall the nozzle, reverse the above instruc-

tions.

Figure 3

Unscrew the retaining nut from the elbow and push the fan nozzle tip and gasket out of the retaining nut. To reinstall the nozzle, reverse

the above instructions.

99944100483

Poly Adjustable Nozzle

Tobera

Buse

99944100482

Brass Adjustable Nozzle

Tobera

Buse

99944100485

Nozzle Kit

Tobera

Buse

Shut-o Assembly

Retaining Nut

Extension Wand

Nozzle Assembly

99944100486

Wand O-ring Kit

Kit del anillo “O”

Trousse de joint torique

Elbow O-ring Hose Washer

Nozzle Gasket Wand O-ring

ECHO, INCORPORATED

400 Oakwood Road

Lake Zurich, IL 60047

www.echo-usa.com

Model# MS-21H Model# MS-31H

In the event that the handle becomes stuck in the lock-on (continuous spraying) position and the tank pressure needs to be relieved,

carefully open the tank and place the wand inside the tank until the pressure is relieved.

99944100477

Shut-of Valve Repair Kit

Kit de reparación para la válvula

de cierre.

Trousse de réparation de robinet

d’arrêt.

99944100478

Shut-o Assembly

Unidad de cierre

Assemblage d’arrêt

99944100480

Extension wand, Vara de extensión, Lance de rallonge

1) Do: Check tightness of hose nut to be sure hose is securely attached to the tank outlet.

2) Do: Inspect hose for deterioration, cracks, softness, or brittleness. If any of these conditions are found, replace hose

before using. Replace with original manufacturer’s parts only.

3) Do: Remove pump (see Filling, Pressurizing and Spraying Instructions), inspect interior and exterior of tank for signs of

deterioration of body and bottom. Any sign of deterioration indicates possible tank weakening and could result in

explosive bursting under pressure. If any of these signs are found, discard tank immediately and replace. Do not attempt

to patch leaks, etc., as this could result in serious injury.

4) Do: Follow Filling, Pressurizing and Spraying Instructions, except use water only (Pump plunger 10-20 strokes and

inspect for leaks).

5) Do: Direct shut-o away from you and open to make sure discharge is not clogged.

6) Do: If unit passes this test, release pressure (see Pressure Releasing Instructions), empty tank, and proceed with Filling,

Pressurizing and Spraying Instructions.

7) Do: Inspect all metal parts including the wand, nozzle and ttings for rust, corrosion and pitting. If any of these

conditions are found, replace aected part with original manufacturer’s part before using.

Sk-1154-1

WARNING: Improper use or failure to follow instructions can result in explosive failure causing serious

eye or other injury. For safe use of this product you must read and follow all instructions. Do not leave a pres-

surized sprayer in the hot sun. Heat can cause pressure build-up resulting in possible explosion. Do not store or

leave solution in tank after use. Always wear goggles, gloves, long sleeve shirt, long pants and full foot protec-

tion when spraying. Never use any tool to remove pump if there is pressure in sprayer. Never stand with face or

body over top of tank when pumping or loosening pump to prevent ejecting pump assembly and/or solution

from striking and injuring you. Never pressurize sprayer by any means other than the original pump. Do not

attempt to modify this sprayer. Replace parts only with manufacturer’s original parts. Never spray ammable,

caustic, acidic, chlorine, bleach or other corrosive solutions or heat, pressure, or gas producing chemicals.

Always read and follow chemical manufacturer’s instructions before use with this sprayer as some chemi-

cals may be hazardous when used with this sprayer.

1) Do: Rinse tank thoroughly with water only, empty, rell with water. Follow Filling, Pressurizing and Spraying Instructions,

except pump unit only 8-10 strokes. Be sure that the wand and nozzle are thoroughly rinsed with water after each use.

2) Do: Open shut-o and allow water to run through discharge assembly.

3) Do: Release pressure (Follow Pressure Release Instructions), remove pump and empty sprayer.

4) Do: Store sprayer tank upside down, with pump removed, in a warm dry location.

5) Do: Periodically oil pump by dropping 10-12 drops of light oil down pump rod through opening in cover.

1. Hose to Tank

Discharge/ Assembly

• Make sure white outlet tube is attached to outlet tube adapter (Fig. 1A).

• Insert the outlet tube portion of the discharge assembly into the tank adapter (Fig. 1B).

• Proper placement of white outlet tube (Fig. 1C).

• Firmly insert the outlet tube adapter into the tank adapter (Fig. 1D) Lining up tab

with notches on the tank adapter.

• Firmly tighten the retaining nut to the tank adapter (Fig. 1E).

Discharge

Assembly

Outlet

Tube

Retaining Nut -

Securely tightened.

Gap

Tank

Adapter

Outlet Tube

Adapter

Tab/

Notch

Outlet Tube

Adapter

Outlet

Tube

6. Pressurizing and Spraying

Do: Turn handle clockwise to

tighten. Push handle down, turn

1/4 turn counterclockwise to

release.

Do: Pump until you feel

resistance.

Do: Push handle, down, turn

1/4 turn clockwise to lock. Begin

spraying. Re-pump sprayer as

required to maintain spray force.

7. To Release Pressure

1) Your sprayer is equipped with a pressure relief/release valve (Fig. 8A).

To release pressure lift and hold the cap until air is completely

exhausted, OR, turn the valve slowly counterclockwise until you hear

air escaping and wait air is completely exhausted (Fig. 8B).

2) Do: Stay away from the sprayer until all air has escaped.

7A 7B

569033

Pressure Relief Valve

Válvula de descarga de presión

Soupape de décompression

99944100479

Hose Assembly

Ensamblaje de la manguera

Assemblage de boyau

569034

Repair Kit

Juego de reparación

Kit de réparation

1 2 3

Inhaltsverzeichnis

Seite 1 - Lake Zurich, IL 60047

WARNINGParts, Piezas, Pièces99944100484Flat Fan NozzleToberaBuse2. Assembly of Shut-off, Extension Wand and Nozzle1) Screw nozzle assembly onto thread

Seite 2

WARNINGParts, Piezas, Pièces99944100484Flat Fan NozzleToberaBuse2. Assembly of Shut-off, Extension Wand and Nozzle1) Screw nozzle assembly onto thread

Seite 3

WARNINGParts, Piezas, Pièces99944100484Flat Fan NozzleToberaBuse2. Assembly of Shut-off, Extension Wand and Nozzle1) Screw nozzle assembly onto thread

Verwandte Modelle: MS-21H

Kommentare zu diesen Handbüchern

Keine Kommentare

Echo MS-31H Bedienungsanleitung

Stöbern Sie online oder laden Sie Bedienungsanleitung nach Gartengeräte Echo MS-31H herunter. Echo MS-31H User Manual Benutzerhandbuch

Inhaltsverzeichnis

Verwandte Modelle: MS-21H

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Gartengeräte Echo MS-31H