Echo PPT-2100 Bedienungsanleitung PDF herunterladen (Seite 12)

SERVICE PROCEDURE

PPF-2100 PPT-2100

PPT-2400 PPFD-2400

2-10 Assembling gear case

1. Clean sealing channels thoroughly on upper

and lower case housings.

2. Apply thin bead of black 100% silicon rubber

sealant (DOW #732, Loctite #593 or equivalent)

into channels.

NOTE: Make sure to apply sealant on to

channels cut in bearing support area on both

halves of gear housings.

3. Install gear sets.

4. Apply 17 g (6 oz) of lithium based grease to

gears and gear housings.

5. Install four 3 mm hex socket bolts, tightening to

torque specification of 2.5 - 4.0 N•m (25 - 40

kgf•cm) (29 - 46 in•lbs).

6. Install worm gear onto sprocket shaft. (Refer to

2-6 Inserting worm gear.)

7. Connect outlet oil line (A) to auto-oiler.

8. Apply small amount of lithium based grease to

worm gear and install auto-oiler with outlet oil line.

9. Secure auto-oiler with two hex socket bolts

applying sealant (Loctite #242 or equivalent).

10. Install oil tank and route inlet oil line (B)

through gear case and connect the oil line to auto-

oiler.

11. Install washer, sprocket, another washer and

E-ring (C).

NOTE: Bevel of E-ring must face washer as

shown.

(A)

(B)

(C)

1 2 ... 7 8 9 10 11 12

Keine Kommentare

Echo PPT-2100 Bedienungsanleitung Seite 12