Echo PE-230 Bedienungsanleitung PDF herunterladen (Seite 21)

POWER EDGER

OPERATOR'S MANUAL

NOTE

Every unit is run at the factory and the carburetor is set in compli-

ance with emissions regulations. This carburetor does not have

acceleration and high speed adjustment needles.

1. Check idle speed and reset if necessary. If a tachometer is avail-

able, idle speed screw (A) should be set to the specifications found

on page 9 "Specifications" of this manual. Turn idle screw (A)

clockwise to increase idle speed; counter clockwise to decrease idle

speed.

WARNING DANGER

When carburetor adjustment is completed, the cutting attach-

ment should not turn at idle, otherwise serious personal injury

may result.

DRIVE SHAFT LUBRICATION

Level 1.

Tools required: 8 mm Open End Wrench, 4 mm Hex Wrench,

Clean rag

Parts Required: ECHO

LUBE

8 oz. (P/N 91014) or Lithium Base

Grease.

1. Loosen two (2) screws (A) and remove center locating screw (B).

Pull gear box and shield from drive shaft housing.

2. Pull flexible cable from the drive shaft housing, wipe clean and

recoat with a thin coating [15 ml (1/2 oz.)] of grease.

3. Slide the flexible cable back in the drive housing. DO NOT get

dirt on the flex cable.

4. Install the gear housing and shield assembly.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 27 28

Keine Kommentare

Echo PE-230 Bedienungsanleitung Seite 21