
SERVICE INFORMATION
CS-2600ES
CS-2700ES
11
2-3 Adjusting carburettor (Continued)
8. After adjusting carburettor, put new limiter cap on
the other side of limiter cap tool as shown, and press
the limiter caps to the bottoms on L and H mixture
needles respectively.
H
L
(A)
(B)
(B)
(A)
NOTE : Align the limiter cap’s tabs (A) with locating
slots (B) in extended housing of carburettor.
IMPORTANT : The limiter caps must be installed
L and H mixture needles to comply with
Emission Directive.
9. Start engine again and make it sure engine runs
at idle speed in the range of 3,000 to 3,600 r/min
and at WOT engine speed in the range of 10,500 to
11,500 r/min. Also make it sure chain would not
turn at engine idle speed and suitable acceleration.
NOTE : Initial carburettor setting (Idle adjust screw,
L and H mixture needles) shown here is to start the
engine after restoration or carburettor change. Idle
adjust screw, L and H needles turn for designated
engine revolution through procedures indicated here
may vary. As long as idle and WOT engine speed is
set in given range, variance would be ignorable.
Kommentare zu diesen Handbüchern