
27
CS-310
Oil lter
Fuel lter
Oil tank cap
Fuel tank cap
0.65 mm (0.026 in.)
AIR FILTER
• Check before every use.
• Release the cylinder cover latches, and remove
the cylinder cover and air lter.
• Brush off dust lightly, or clean with compressed
air, or replace the air lter.
• Reinstall air lter and the cylinder cover, engage
latches.
CHECK FUEL SYSTEM
• Check before every use.
• After refueling, make sure fuel does not leak
from around fuel pipe, fuel grommet or fuel tank
cap.
• In case of fuel leakage there is a danger of re.
Stop using the machine immediately and re-
quest your dealer to inspect or replace.
SPARK PLUG
• Check periodically.
• The standard spark gap is 0.65 mm
(0.026 in.).
• Correct the spark gap if it is wider or
narrower than the standard gap.
• Fastening torque: 150 to 170 Kgf • cm
(130 to 145 in • lbf).
FUEL FILTER
• Check periodically.
• Do not allow dust to enter fuel tank.
• A clogged lter will cause difculty in starting
engine or abnormalities in engine performance.
• Pull the fuel lter out through fuel inlet port with
a piece of steel wire or the like.
• When the lter is dirty, replace it.
• When the inside of the fuel tank is dirty, rinsing
the tank out with gasoline can clean it.
OIL FILTER
• Check periodically.
• Do not allow dust to enter into oil tank.
• A clogged oil lter will affect the normal lubricat-
ing system.
• Pull it out through oil lling hole with a piece of
steel wire or the like.
• If the lter is dirty, wash it in gasoline or replace
it.
• When the inside of the tank gets dirty, rinsing the
tank out with gasoline can clean it.
Cylinder cover latch
Air lter
Cylinder cover
Cylinder cover latch
Kommentare zu diesen Handbüchern